Printare 3D Jobs

I have a Tech Pack for our new shoe design and am needing an experienced 3D designer to do our 3D Version of the shoe. Must be experienced and will need to sign a NDA to work with us. We will be needing to do a 3D print of the shoe on completion Thanks Please note we are only interested in 3D Designers who specialise in 3D Shoe design Thanks

I want a mask of the villain Kai from Kung Fu Panda 3. Not just a face mask but covers the whole face.

I need help with my 3D printer. I just releveled it and it still isn't printing right. It keeps layering and getting messed up and going everywhere.

Our company sends Microsoft Word files to a robotic handwriting machine so it can handwrite both letters and envelopes. There is a feeder attached to the back of the writing machine. This is where the letters and envelopes are placed before getting fed into the robot. The feeder is screwed into the base of the robot. The feeder houses a small motor that plugs into the robot. When we start the writing program from Word, the feeder sends a card or envelope to the robot which starts writing. When the robot is done writing one letter or envelope, a sensor in the robot triggers the motor in the feeder which spins the rollers that sends the next letter or envelope. Currently, the feeder can only hold about 60 letters at a time (about ¾ of an inch). If we need to write more than 60 le...

Necesito una pieza en 3D, tengo imágenes y un modelo en 3D de como sería. Busco la pieza Azul y El gatillo Rojo

i need lion ring model done quickly more details will be shared in chat thanks

I need a 3D model that can be edited and modified with Fusion 360 for 3D printing. The model should be based on the attached cut-away diagram. The diagram consists of 8 different parts as follows. 30in conductor housing: Light blue 18 3/4in wellhead housing: Blue 7in casing hanger: Green 9 5/8in casing hanger: Light Green 13 3/8in casing hanger: Turquoise Temporary Abandonment Cap: Orange 3 x Pack off: Dark Blue (only 1 needed as they are similar) To produce the 3D models, the diagram can be revolved as all the components are round. The grey pipe fitted to the bottom of each component with be produced separately with threads and screwed onto the components. Every part should be produced according to the measurements as they will be 3D printed and assembled afterwards. The largest componen...

I'm looking to develop a very simple battery operated device. It is to be a circular, puck shaped device (circle 5" diameter, 1" thick). The front face contains a large button with a speaker behind it. When the button is pressed, a sound (to be determined: white noise, ocean wave, rainfall, something like this) will play for 3 minutes. After 3 minutes, the sound stops. Pressing the button again will start the sound again for 3 min, and so in. There are no other settings or controls, just this button to start the sound. The device should run on AA or 9volt batteries, (I'm open to suggestions on the pros and cons, I just want the longest life- i.e. how many 3 minute cycles can I achieve without changing the batteries? A successful prototype of this simple device ...