Altium Designer Jobs

I am looking for an experienced power electronics engineer or engineering team to design a residential-scale hybrid solar inverter for commercial production. The project involves developing a single-phase, 230 V AC, 50 Hz pure sine-wave hybrid inverter that integrates rooftop solar panels, a lithium battery bank and the utility grid. The design should prioritise high efficiency, reliability, safety and ease of manufacturing. I prefer an engineer with previous experience designing working solar inverters, grid-connected converters, MPPT controllers and bidirectional battery systems. An existing, validated reference design that can be licensed or transferred is preferred. 1. Target Specifications Rated power: 1–5 kW continuous AC output: 230 V RMS, single phase, 50 Hz Output wave...

Status: Schematic is finalized — layout work only (with expert schematic/BOM review). Project Overview I need an experienced PCB designer to create the PCB layout for a small precision encoder module with Bluetooth Low Energy (BLE) connectivity. The complete electronic schematic and BOM are already defined; your task is the board layout, design review, and preparation of full manufacturing data. A schematic review is required to confirm correctness before placement begins. Board Architecture: The board contains two functionally independent sections, which must be physically separated to avoid mutual interference: - Encoder section: STM32G474 microcontroller and its supporting peripherals, two AM26LV32E differential line receivers and ESDA6V1SC6 ESD protection device. - Bluetooth se...

We’re looking for an experienced PCB designer with strong expertise in EMC-conscious layouts and safety standards. The schematic, reference images, and mechanical requirements are already available. We need a clean 4-layer PCB layout (approx. 170 × 93 mm). The board includes 230V mains and low-voltage sections, so proper clearance/creepage distances, design rules, GND/VCC planes, and an EMC-conscious layout are important. Experience with Surge, EFT, and ESD protection would be great. The project is urgent, requiring completion by next week.

I’m ready to move an industrial-grade project from concept to a fully routed, production-ready multi-layer PCB. The board will sit inside rugged equipment, so clean signal integrity, controlled impedance where needed, and rock-solid power distribution are critical. Here’s what I will hand over: • Finished schematic (updated from my draft, or created from your netlist). • Optimized multi-layer stack-up with clear documentation of dielectric thicknesses and copper weights. • Complete routing in Altium Designer or KiCad—your choice—adhering to IPC standards. • DRC-clean Gerber, drill, pick-and-place, and IPC-356 netlist files. • An accurate BOM with manufacturer part numbers and alternates. • Assembly drawings and 3D STEP model ...