i need as follows
- a mosfet to act as an inline relay to control power to a iginition coil (four coils to be controlled by one mosfet just to get or to not get 12v, ground of each coil pwm controlled via ecu)
- i need to map an input value that later is dependant of a potentiometer signal
first input i have x revolutions per minute and a given value of a potientiomenter and depending where this one is it will have to move a stepper motor (that actuas as a flow valve) to certain degrees of open or close, higher pot value more open and smaller values less open.
by the way, say hay pete so i know you have read this
the stepper needs first to "learn its position" from 0 to 90deg via consuption hitting the lock point (higher power drain) not via end run switches, this is to controll a exhaust valve.
Hi, it's me, Ajay. Thanks for posting this project. I am sure I will complete this project in no time.
4 freelanceri licitează în medie 26€ pentru acest proiect
hi i am interested to work on your project. i can satisfy your requirement. it would be my pleasure to serve you.
Hello! Nice to meet you! I have read your project carefully. I am very interested in your project. I am a Microelectronics and Automation engineering expert. I have a lot of experience on ARM, FPGA, DSP, Arduino, Raspb Mai multe
Hello! I am the right choice for this project. I have my own team of engineers and we are formerly named as “ACADEMICSASSISTANT”. We did a very similar project before and we can share video with you also. For your proj Mai multe