I need C programming help

Hello

Im stuck on C programming problems.

1. Using a photo sensor, display the binary output of the measured light on the 10 segment LED block. Use a switch (not a button) to put the system into one or the other of two modes. The display must range from near 0 to near 1023.

Mode 1: Display the measured light continuously.

Mode 2: Capture the measured light when a push button has been pressed (the button must be debounced and cannot be held down) and display it on the LED block.

LED bar P6.0-6.7 and P1.5-1.6, we use hex to do pin set up, the button is on P2.5 and the switch is on P3.6

2. Read a letter (a-z) from the serial monitor and display the corresponding Morse code

on an LED and in text on the monitor (dot dot dash). You must use an array to retrieve

the appropriate Morse code.

Serial monitor : MSP432P401R, 3.3V we are using

Who can help me?

Thanks

Programare C Programare C# Arhitectură software Programare C++

ID Proiect: #29322563

Detalii despre proiect