Programming iMX8 GPIO
$30-250 USD
S-au achitat serviciile după ce au fost prestate
We are looking for code to generate the signals (as seen in signal.jpg-attached) on GPIO pins of iMX8 microprocessor. The clock frequency is 25Mhz
With a delay starting at 7 Nano Seconds and going up to 625 Nano Seconds, with 40 clock pulses finishing within 2.38micro seconds.
In the diagram attached, ts width= 625ns, ts1-s2 delay=150ns, ts-p delay=42.5ns
More details will be shared with whomever is chosen.
We need a quick turn around, output needed in 1week maximum.
Coding language has to be C/C++ and OS on MPU Linux
ID Proiect: #31886861
Detalii despre proiect
6 freelanceri plasează o ofertă medie de 389$ pentru proiect
I'm an experienced Linux system administrator with more than 5 years of experience in enterprise environments working mainly with RHEL (5,6 and 7) and SLES (10,11 and 12). I'm working with confidence with the following Mai multe
Good morning, I quote about 2.5 days work so we can exchange and adjust the solution. In principle an ARM processor board such as beagleboard, raspberry or similar will be fit for this work, along with certainly C/C++ Mai multe
Hello, I have 10+ years of Embedded product design with multiple domains like a consumer, industrial, automotive, IOT and wearable product. -Hardware architecture design using MCU, controller, and FPGA, as well as low Mai multe
I have reviewed your bid request and I am very interested in your project. I was trained overseas and have an extensive customer service record so contact me so we can discuss further or begin.
We are a Product Design and Development company with expertise in embedded systems and robotics . We provide Services such as Embedded Firmware Development for Controllers and Processors , Embedded Hardware Design and Mai multe