I have been working on a custom board based around the STM32F746IGT6 MCU, external SDRAM (AS4C4M16SA-6TIN) and external flash (MT25QL128ABA1ESE-0SIT) to run a 7in, 800x480 display (4DLCD-70800480-CTP). However, I have been facing flickering issues with the display, so a board redesign may be necessary.
The project is to redesign the board to successfully drive the LCD display.
Here are the requirements:
1. Make a custom board with a STM32F7 or STM32H7, with external SDRAM and external FLASH to run the TFT display through the LTDC interface, in 24-bit mode. The display would be ran in double buffer mode, so the SDRAM need to be big enough to accommodate that. Ideally, the external flash should be as big as possible. The end goal is to be able to run smooth animations on the display.
2. Add/write the I2C touch panel drivers based around the FT5436 IC.
Current schematics and PCB layout can be shared upon request to help understand the requirements of this project and deliver a more accurate quote.
17 freelanceri licitează în medie 1149$ pentru acest proiect
Best PCB Design Expert at your doorstep! Dear Client, We can design 7in 800x480 TFT display with touch panel based around STM32 as per your requirements. Please share me your existing schematics and PCB layout for bet Mai multe
Hi sir, I already designed TFT LCD boards for STM32. I used both RGB888 and MIPI DSI interfaces. lets talk to me on your project. Regards, Ahmed
Hello, I am ready to make the best PCB design for you, select the optimal components and make circuit adjustments according to your requirements.
Hi YannTal, I am an electronics engineer familiar with circuit design, multi layer and high speed signal PCB layout. In previous works I have designed the wearable IoT with RGB color LCD, camera module and WIFI module Mai multe
Hi there, We can help you in this project as do have specialization in STM controller. I came across with your job post very carefully. Please review our work in STM controller:- Wireless Alarm System:- https://driv Mai multe
Hello. I’m interested in your project. Please send me message so that we can discuss more. Thank you.
hello sir, how are you. I read your proposal and i am interested in this project. Plz check my portfolio I worked on touch LCD. I am an Embedded engineer (Stm32, PIC, AVR, Arduino, SOC BLE (bluetooth) chips, ZigBee, W Mai multe
Hello I have very high skill with STM32. I have read your job description and i can build it very well. Please contact me. Thanks.
Hello, I am PhD Researcher in Electrical Engineering with specialization in Control Systems (Linear and Nonlinear Control Systems). I have Master's degree in Electrical Engineering and Bachelor's Degree in Electronics Mai multe
Hello. I have rich experience to be developed different LCDs with STM32. Also I have FT3x and FT5x touch panel experience too. Especially I have STM32F746 board. I have been programming STM32 firmware and different dri Mai multe
Hi! I have understood your requirement, about your project with every detail of it. I am an Electrical Engineer with more than 9 years of experience in electronics, circuit design, PCB layout, microcontrollers, Arduin Mai multe
Hello, thank you for your job posting. Actually, I can't stop myself from feeling motivated to do your project. I can work in your timezone and so I can work full-time for you. I would be very grateful if you give me Mai multe
Hello there. I have read your project details and can help you.. I have experience with STM32 project, so can handle this project.. I can design 12 layers PCB. Hope more discuss with you. Thanks..
Hi, I am a System Design Engineer, I can handle the Hardware Design, Firmwae Development and PCB design. I have already developed a similar project where the STM32 MCU will fetch data from the sensors and display it o Mai multe