PIC MICROCONTROLLER DEVLOP

₹600-1500 INR

Închis

Data postării:

peste 2 ani în urmă

₹600-1500 INR

Plata la predare

TWO PIC COMUNICATION THROUGH 433 MHZ RF AND ..(HALF DUPLEX) ONE IS SENDER AND ANOTHER RECIEVER WITH UNIQ CODE AUTHENTICATION (SENDER AND RECIVER HAVE SAME CODE THEN ONLY COMMUNICATION START) SENDER HAS 3 INPUT AND THAT INPUT REFLECT ON RECIVER GPIO OUTPUT PIC IC PREFER: 12F675 SOFTWARE: MPLAB INPUT FROM SENDER AND REFLECT TO RECIVER OUTPUT PIN (ANY CHANGE IN SENDER INPUT IT WILL SEND THE STATUS OF INPUT TO RECIVER AND RECIVER WILL REFLECT TO GPIO PIN

Microcontroller

Electronics

Arduino

Electrical Engineering

C Programming

ID-ul proiectului: 31771656

Despre proiect

4 propuneri

Proiect la distanță

Activ: 2 ani în urmă

Vrei să câștigi bani?

Adresa de e-mail

Avantajele de a licita pe platforma Freelancer

Stabilește bugetul și intervalul temporal

Îți primești plata pentru serviciile prestate

Evidențiază-ți propunerea

Te înregistrezi și licitezi gratuit pentru proiecte

4 freelanceri plasează o ofertă medie de ₹1.738 INR pentru proiect

@etalhak

Hello, I am an electronics and telecommunication engineer and my major is wireless systems' design. I am experienced in hardware and embedded systems' design. So far I have designed/printed/tested many PCBs and I am quite experienced with RF design (antennas, matching networks, filters, power dividers, feed networks, power amplifiers, differential pairs/signals), EMI(Clearance areas,shielding, conducted interference, common mode, etc), LVD, high speed data communication. I have checked your requirements and I am quite sure that I can help you with your project. Just give me all the details and I will do my best to help you. Best regards

₹1.050 INR în 7 zile

5,0

(35 recenzii)

5,3

@cnarvaez1957

Hi I have what you need..fixed code transmitter / receiver using PIC12F675. Code in MPLAB assembler. I can send you simulation in proteus. Thank you for choosing PIC microcontroller is the best option

₹1.500 INR în 7 zile

5,0

(9 recenzii)

4,1

@elect2eng

Hello, I have done this before with ATTiny micro controller. It's a small device. You can program it using Arduino IDE. If you are very particular about PIC, I can do it with PIC/MPLABX

₹3.000 INR în 7 zile